Removal

2011 Lexus HS 250h L4-2.4L (2AZ-FXE) HybridSECTION Removal




MIRROR (EXT): OUTER MIRROR CONTROL ECU: REMOVAL

1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG Disassembly

2. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) Disassembly

3. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) Removal

4. REMOVE DOOR ARMREST COVER Disassembly

5. REMOVE COURTESY LIGHT ASSEMBLY Removal

6. REMOVE NO. 1 FRONT DOOR STIFFENER CUSHION Disassembly

7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

8. REMOVE OUTER MIRROR CONTROL ECU ASSEMBLY

(a) Disconnect each connector.





(b) Remove the 2 screws and outer mirror control ECU assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.