Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2011HS 250H L4-2.4L (2AZ-FXE) HYBRIDREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSKNOCK SENSORSERVICE AND REPAIRINSTALLATION
2011 Lexus HS 250h L4-2.4L (2AZ-FXE) Hybrid
Installation
2011 Lexus HS 250h L4-2.4L (2AZ-FXE) HybridSECTION Installation
2AZ-FXE ENGINE CONTROL: KNOCK SENSOR: INSTALLATION
1. INSTALL KNOCK SENSOR
(a) Install the knock sensor with the nut.
Text in Illustration
Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)
NOTICE:
Make sure that the knock sensor is in the correct position.
(b) Connect the knock sensor connector.
2. INSTALL INTAKE MANIFOLD
(a) Install the intake manifold Installation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.