Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2011HS 250H L4-2.4L (2AZ-FXE) HYBRIDREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGRELAYS AND MODULES - HVACCONTROL MODULE HVACSERVICE AND REPAIRBLOWER MOTOR CONTROLLERREMOVAL
2011 Lexus HS 250h L4-2.4L (2AZ-FXE) Hybrid
Removal
2011 Lexus HS 250h L4-2.4L (2AZ-FXE) HybridSECTION Removal
HEATING / AIR CONDITIONING: BLOWER MOTOR CONTROLLER: REMOVAL
1. PRECAUTION (w/ Navigation System)
NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT Removal
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL Removal
4. REMOVE FRONT CONSOLE BOX COVER Removal
5. REMOVE FRONT CONSOLE UPPER PANEL GARNISH (w/o Seat Heater System) Removal
6. REMOVE FRONT CONSOLE UPPER PANEL GARNISH (w/ Seat Heater System) Removal
7. REMOVE REAR CONSOLE PANEL SUB-ASSEMBLY Removal
8. REMOVE CONSOLE BOX CARPET Removal
9. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY Removal
10. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal
11. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal
12. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY (w/o Navigation System) Removal
13. REMOVE REMOTE TOUCH ASSEMBLY (w/ Navigation System) Removal
14. REMOVE CONSOLE BOX LH Removal
15. REMOVE CONSOLE BOX RH Removal
16. REMOVE FRONT DOOR SCUFF PLATE RH
HINT
Use the same procedure for the RH side and LH side Removal.
17. REMOVE FRONT DOOR OPENING TRIM COVER RH
HINT
Use the same procedure for the RH side and LH side Removal.
18. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal
19. REMOVE COWL SIDE TRIM BOARD RH
HINT
Use the same procedure for the RH side and LH side Removal.
20. REMOVE INSTRUMENT SIDE PANEL RH Removal
21. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Removal
22. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Removal
23. REMOVE CONSOLE BOX Removal
24. REMOVE NO. 2 CONSOLE BOX MOUNTING BRACKET Removal
25. REMOVE NO. 1 CONSOLE BOX MOUNTING BRACKET Removal
26. REMOVE BLOWER MOTOR CONTROLLER
(a) Disconnect the connector.
(b) Remove the 2 screws and blower motor controller.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.