Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2011HS 250H L4-2.4L (2AZ-FXE) HYBRIDREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTANTITHEFT AND ALARM SYSTEMSTESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURESSMART ACCESS SYSTEM WITH PUSH-BUTTON START (FOR ENTRY FUNCTION)ENTRY ANSWER-BACK BUZZER DOES NOT SOUND
2011 Lexus HS 250h L4-2.4L (2AZ-FXE) Hybrid
Entry Answer-Back Buzzer Does Not Sound
2011 Lexus HS 250h L4-2.4L (2AZ-FXE) HybridSECTION Entry Answer-Back Buzzer Does Not Sound
THEFT DETERRENT / KEYLESS ENTRY: SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Entry Function): Entry Answer-back Buzzer does not Sound
- Entry Answer-back Buzzer does not Sound
DESCRIPTION
The smart access system with push-button start uses the wireless door lock buzzer assembly to perform various vehicle exterior warnings. When the conditions for each warning are met, the certification ECU (smart key ECU assembly) sends a buzzer request signal to the main body ECU (multiplex network body ECU) via CAN communication. The wireless door lock assembly sounds the buzzer according to the signal from the main body ECU (multiplex network body ECU).
INSPECTION PROCEDURE
NOTICE:
The smart access system with push-button start (for entry function) uses a LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting How To Proceed With Troubleshooting. Troubleshoot the smart access system with push-button start (for entry function) after confirming that the communication system is functioning properly.
PROCEDURE
1. READ VALUE USING TECHSTREAM (ANSWER-BACK BUZZER FUNCTION)
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Data List.
(e) Read the Data List according to the display on the Techstream.
Main Body (Main Body ECU (Multiplex Network Body ECU))
Result:
B -- PERFORM CUSTOMIZE SETTING (Proceed to Customize Parameters) Smart Access System With Push-Button Start (for Entry Function)
A -- Continue to next step.
2. PERFORM ACTIVE TEST USING TECHSTREAM
(a) Enter the following menus: Body Electrical / Main Body / Active Test.
(b) Perform the Active Test according to the display on the Techstream.
Main Body (Main Body ECU (Multiplex Network Body ECU))
OK:
Wireless door lock buzzer sounds.
NG -- GO TO WIRELESS DOOR LOCK CONTROL SYSTEM (Proceed to No Answer-Back) No Answer-Back
OK -- REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) Removal
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.