Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2009ES 350 V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSRAIN SENSORSERVICE AND REPAIRREMOVAL
2009 Lexus ES 350 V6-3.5L (2GR-FE)
Removal
2009 Lexus ES 350 V6-3.5L (2GR-FE)SECTION Removal
WIPER AND WASHER: RAIN SENSOR:
REMOVAL
1. REMOVE RAIN SENSOR COVER
(a) Remove the rain sensor cover.
2. REMOVE RAIN SENSOR
HINT: This step should be performed only when the rain sensor tape needs to be replaced.
(a) Release the stopper by pulling the stopper down and disconnect the rain sensor as shown in the illustration.
(b) Disconnect the connector and remove the rain sensor.
3. REMOVE RAIN SENSOR TAPE
HINT: This step should be performed only when the rain sensor tape needs to be replaced.
(a) Remove the rain sensor tape.
NOTE:
The rain sensor tape can be reused, however, replace it with a new one if it is dirty or damaged.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.