Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2009ES 350 V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSRELAYS AND MODULES - RESTRAINTS AND SAFETY SYSTEMSAIR BAG CONTROL MODULESERVICE AND REPAIRREMOVAL
2009 Lexus ES 350 V6-3.5L (2GR-FE)
Removal
2009 Lexus ES 350 V6-3.5L (2GR-FE)SECTION Removal
SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY:
REMOVAL
1. PRECAUTION
CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing Service Precautions.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
3. REMOVE FRONT DOOR SCUFF PLATE LH Removal
4. REMOVE FRONT DOOR OPENING TRIM COVER LH Removal
5. REMOVE SIDE INSTRUMENT PANEL LH Removal
6. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal
7. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY Removal
8. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal
9. REMOVE FRONT DOOR SCUFF PLATE RH Removal
10. REMOVE FRONT DOOR OPENING TRIM COVER RH Removal
11. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal
12. REMOVE SIDE INSTRUMENT PANEL RH Removal
13. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Removal
14. REMOVE LOWER INSTRUMENT PANEL RH Removal
15. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal
16. REMOVE UPPER CONSOLE PANEL ASSEMBLY WITH FRONT ASH RECEPTACLE Removal
17. REMOVE CONSOLE BOX POCKET Removal
18. REMOVE CONSOLE BOX CARPET Removal
19. REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY Removal
20. REMOVE REAR CONSOLE BOX ASSEMBLY Removal
21. REMOVE FLOOR CARPET BRACKET LH Removal
22. REMOVE FLOOR CARPET BRACKET RH Removal
23. REMOVE NO. 2 CONSOLE BOX DUCT Removal
24. REMOVE NO. 3 CONSOLE BOX DUCT Removal
25. REMOVE NO. 1 CONSOLE BOX DUCT Removal
26. REMOVE CENTER AIRBAG SENSOR ASSEMBLY
(a) Turn back the carpet.
(b) Disconnect the holder (with connectors).
(c) Remove the 3 bolts and center airbag sensor assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.