Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2009ES 350 V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISMAINTENANCEWHEELS AND TIRESTIRE MONITORING SYSTEMTIRE PRESSURE MODULESERVICE AND REPAIRREMOVAL
2009 Lexus ES 350 V6-3.5L (2GR-FE)
Removal
2009 Lexus ES 350 V6-3.5L (2GR-FE)SECTION Removal
TIRE AND WHEEL: TIRE PRESSURE WARNING ECU:
REMOVAL
NOTE:
Before removing the tire pressure warning ECU, read the registered transmitter IDs of all wheels and write them down to use for re-registration of transmitter IDs Registration.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
2. REMOVE FRONT DOOR SCUFF PLATE RH Removal
3. REMOVE FRONT DOOR OPENING TRIM COVER RH Removal
4. REMOVE INSTRUMENT SIDE PANEL RH Removal
5. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal
6. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal
7. REMOVE PASSENGER SIDE KNEE AIRBAG ASSEMBLY Removal
8. REMOVE LOWER INSTRUMENT PANEL RH Removal
9. REMOVE TIRE PRESSURE WARNING ECU
(a) Remove the nut.
(b) Disconnect the connector and remove the tire pressure warning ECU.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.