Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2009ES 350 V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCLIMATE CONTROL EXHAUST GAS SENSORSERVICE AND REPAIRINSTALLATION
2009 Lexus ES 350 V6-3.5L (2GR-FE)
Installation
2009 Lexus ES 350 V6-3.5L (2GR-FE)SECTION Installation
AIR CONDITIONING: SMOG VENTILATION SENSOR:
INSTALLATION
1. INSTALL SMOG VENTILATION SENSOR
(a) Install the smog ventilation sensor with the bolt.
Torque: 9.8 Nm (100 kgf-cm, 87 in-lbf)
(b) Connect the connector.
2. INSTALL COOL AIR INTAKE DUCT SEAL Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.