Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS1999RX 300 AWD V6-3.0L (1MZ-FE)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINESYSTEM SPECIFICATIONSCONNECTING ROD BOLT
1999 Lexus RX 300 AWD V6-3.0L (1MZ-FE)
Connecting Rod Bolt
1999 Lexus RX 300 AWD V6-3.0L (1MZ-FE)SECTION Connecting Rod Bolt
Connecting Rod Bolts
Standard Diameter 7.2 - 7.3 mm (0.284 - 0.287 inch)
Minimum Diameter 7.0 mm (0.276 inch)
Tightening torque:
Step 1 24.5 Nm (18 ft lb)
Step 2 Turn 90°
- Apply a light coat of engine oil on the threads and under the heads of the connecting rod cap bolts.
- Install and alternately tighten the 2 connecting rod cap bolts in several passes.
Standard Diameter 7.2 - 7.3 mm (0.284 - 0.287 inch)
Minimum Diameter 7.0 mm (0.276 inch)
Tightening torque:
Step 1 24.5 Nm (18 ft lb)
Step 2 Turn 90°
- Apply a light coat of engine oil on the threads and under the heads of the connecting rod cap bolts.
- Install and alternately tighten the 2 connecting rod cap bolts in several passes.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.