Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS1999RX 300 AWD V6-3.0L (1MZ-FE)REPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCOMPRESSOR SPEED SENSORTESTING AND INSPECTION
1999 Lexus RX 300 AWD V6-3.0L (1MZ-FE)
Compressor Speed Sensor: Testing and Inspection
1999 Lexus RX 300 AWD V6-3.0L (1MZ-FE)SECTION Testing and Inspection
INSPECT COMPRESSOR LOCK SENSOR RESISTANCE
a. Disconnect the connector.
b. Measure resistance between terminals 1 and 2.
Standard resistance: 65 - 125 ohms at 20° C (68° F)
If resistance is not as specified, replace the compressor assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.