Torque Specifications

2009 Land Rover Range Rover Sport (LS) V8-4.4LSECTION Torque Specifications

Torque Specifications

4.2 Liter
Compressor Mounting Bolts 25 Nm (18 ft. lbs.)
Receiver/Drier Mounting Bolts 10 Nm (7 ft. lbs.)
Refrigerant Line Bolts 6 Nm (4 ft. lbs.)
Condenser Core Bolts 6 Nm (4 ft. lbs.)
A/C Pipe To Condenser Bolts 6 Nm (4 ft. lbs.)
Coolant Expansion Tank Bolts 10 Nm (7 ft. lbs.)
Heater Housing To Bulkhead Torx Bolts 6 Nm (4 ft. lbs.)
Adaptor Panel Nuts 6 Nm (4 ft. lbs.)
Air Conditioning Lines To Bulkhead Bolt 6 Nm (4 ft. lbs.)
Air conditioning lines to body nut 6 Nm (4 ft. lbs.)
Instrument Panel Torx Bolts 25 Nm (18 ft. lbs.)
Instrument Panel Carrier To Bulkhead Torx Bolt 25 Nm (18 ft. lbs.)
* Steering Column Intermediate Shaft Nut 22 Nm (16 ft. lbs.)
Ground Cables To Passenger Side Lower A-Pillar Nuts 10 Nm (7 ft. lbs.)
Ground Cables To Driver Side Lower A-Pillar Nuts 10 Nm (7 ft. lbs.)
Pressure Transducer 10 Nm (7 ft. lbs.)
Power Steering Pump Mounting Bracket Bolts 25 Nm (18 ft. lbs.)
Supercharger Radiator Bolts 10 Nm (7 ft. lbs.)
THermostatic Expansion Valve 5 Nm (4 ft. lbs.)

* New Nut Must Be Installed

4.4 Liter
Compressor Mounting Bolts 25 Nm (18 ft. lbs.)
Receiver/Drier Mounting Bolts 10 Nm (7 ft. lbs.)
Refrigerant Line Bolts 6 Nm (4 ft. lbs.)
Condenser Core Bolts 6 Nm (4 ft. lbs.)
A/C Pipe To Condenser Bolts 6 Nm (4 ft. lbs.)
Coolant Expansion Tank Bolts 10 Nm (7 ft. lbs.)
Heater Housing To Bulkhead Torx Bolts 6 Nm (4 ft. lbs.)
Adaptor Panel Nuts 6 Nm (4 ft. lbs.)
Air Conditioning Lines To Bulkhead bolt 6 Nm (4 ft. lbs.)
Air Conditioning Lines To Body Nut 6 Nm (4 ft. lbs.)
Instrument Panel Torx Bolts 25 Nm (18 ft. lbs.)
Instrument Panel Carrier To Bulkhead Torx Bolt 25 Nm (18 ft. lbs.)
* Steering Column Intermediate Shaft Nut 22 Nm (16 ft. lbs.)
Ground Cables To Passenger Side Lower A-Pillar Nuts 10 Nm (7 ft. lbs.)
Ground Cables To Driver Side Lower A-Pillar Nuts 10 Nm (7 ft. lbs.)
Pressure Transducer 10 Nm (7 ft. lbs.)
Power Steering Pump Mounting Bracket Bolts 25 Nm (18 ft. lbs.)
Supercharger Radiator Bolts 10 Nm (7 ft. lbs.)
Thermostatic Expansion Valve 5 Nm (4 ft. lbs.)

* New Nut Must Be Installed
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.