Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1985WAGONEER V6-173 2.8L VIN W 2-BBLREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSDESCRIPTION AND OPERATIONGENERAL SYSTEM DESCRIPTIONINPUTS AND OUTPUTS
1985 Jeep Wagoneer V6-173 2.8L VIN W 2-bbl
Inputs and Outputs
1985 Jeep Wagoneer V6-173 2.8L VIN W 2-bblSECTION Inputs and Outputs
The ``E'' cell controls voltage at ECM terminal 15. For the first 25,000 miles of vehicle operation, voltage is nearly zero. The ``E'' cell then causes voltage to rise to approximately 5 volts. This provides a different control value for some systems.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.