Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1985GRAND WAGONEER L6-258 4.2L VIN C 2-BBLREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCOOLANT TEMPERATURE SENSOR/SWITCH (FOR COMPUTER)SERVICE AND REPAIR
1985 Jeep Grand Wagoneer L6-258 4.2L VIN C 2-bbl
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
1985 Jeep Grand Wagoneer L6-258 4.2L VIN C 2-bblSECTION Service and Repair
The coolant temperature switch is integral with the intake manifold heater coolant temperature control switch, located at the rear of the intake manifold.
1. Disconnect electrical connector and remove switch.
2. Reverse procedure to install. Torque to 72 inch lbs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.