Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1985CHEROKEE 4WD L4-150 2.5L VIN U 1-BBLREPAIR AND DIAGNOSISCRUISE CONTROLADJUSTMENTS
1985 Jeep Cherokee 4WD L4-150 2.5L VIN U 1-bbl
Cruise Control: Adjustments
1985 Jeep Cherokee 4WD L4-150 2.5L VIN U 1-bblSECTION Adjustments
REGULATOR ADJUSTMENTS
The regulator adjustments are pre-set by the manufacturer. However, if all of the other components of the system appear to be functioning normally and the speed control system remains inoperative, perform the adjustments below to determine if the regulator is working properly.
Fig. 11 Speed control regulator adjustments:
Pre-Adjustment
Turn the sensitivity adjustment screw fully clockwise, and the low speed and centering adjusting screws to the 10 o'clock position as shown. The adjustment screws are extremely delicate. Insert the screwdriver into the slots carefully to avoid damaging regulator.
Centering Adjustment
Road test vehicle and observe engagement speed. If speed control engages at 2 mph or greater than the selected road speed, turn centering adjusting screw counterclockwise in small increments. If engagement speed is 2 or more mph below selected speed, turn adjusting screw clockwise in small increments. Check for proper centering adjustment by engaging speed control system on a level road after each adjustment is completed. If adjustments have no effect on system operation, replace the regulator.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.