Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR1991XJ-6 L6-4.0LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGSOLAR SENSORSERVICE AND REPAIR
1991 Jaguar XJ-6 L6-4.0L
Solar Sensor: Service and Repair
1991 Jaguar XJ-6 L6-4.0LSECTION Service and Repair
Removal and Installation
1. Open the bonnet and disconnect the battery earth lead.
2. Carefully pry the solar sensor panel from the top of the fascia (1)
3. Disconnect the multi-pin cable harness connector.
4. Remove the complete solar sensor assembly (2).
5. Remove the spire clips (3) securing the sensor to the assembly and remove the sensor (4).
NOTE: Installation is the reverse of the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.