Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2002Q45 V8-4.5L (VK45DE)REPAIR AND DIAGNOSISLIGHTING AND HORNSHEADLAMPHEADLAMP ALIGNMENT CONTROL MODULESERVICE AND REPAIR
2002 Infiniti Q45 V8-4.5L (VK45DE)
Headlamp Alignment Control Module: Service and Repair
2002 Infiniti Q45 V8-4.5L (VK45DE)SECTION Service and Repair
Removal and Installation
1. Remove the lower instrument panel (driver side). Refer to "Removal and Installation" in "INSTRUMENT PANEL (IP)".
2. Press the headlamp aiming switch fixing tabs and remove the unit from the instrument lower panel (driver side).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.