Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2002I35 V6-3.5L (VQ35DE)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSAUTOMATIC TRANSMISSION/TRANSAXLESYSTEM SPECIFICATIONS
2002 Infiniti I35 V6-3.5L (VQ35DE)
System Specifications
2002 Infiniti I35 V6-3.5L (VQ35DE)SECTION System Specifications
General Specifications
Shift Schedule
VEHICLE SPEED WHEN SHIFTING GEARS THROTTLE POSITION
VEHICLE SPEED WHEN PERFORMING AND RELEASING LOCK-UP
NOTE:
- Lock-up vehicle speed indicates the speed in D4 position.
- Perform lock-up inspection after warming up engine.
- Lock-up vehicle speed may vary depending on the driving conditions and circumstances.
Stall Revolution
Line Pressure
Control Valves
CONTROL VALVE AND PLUG RETURN SPRINGS
Accumulator
O-RING
RETURN SPRING
Clutch and Brakes
REVERSE CLUTCH
HIGH CLUTCH
FORWARD CLUTCH
OVERRUN CLUTCH
LOW & REVERSE BRAKE
BRAKE BAND
CLUTCH AND BRAKE RETURN SPRINGS
Final Drive
DIFFERENTIAL SIDE GEAR CLEARANCE
DIFFERENTIAL SIDE GEAR THRUST WASHERS
DIFFERENTIAL SIDE BEARING PRELOAD ADJUSTING SHIMS
BEARING PRELOAD
TURNING TORQUE
CLUTCH AND BRAKE RETURN SPRINGS
Planetary Carrier and Oil Pump
PLANETARY CARRIER
OIL PUMP
Input Shaft
SEAL RING CLEARANCE
SEAL RING
Reduction Pinion Gear
TURNING TORQUE
REDUCTION PINION GEAR BEARING ADJUSTING SHIMS
Band Servo
RETURN SPRING
Output Shaft
SEAL RING CLEARANCE
SEAL RING
END PLAY
OUTPUT SHAFT ADJUSTING SHIMS
Bearing Retainer
SEAL RING CLEARANCE
Total End Play
BEARING RACE FOR ADJUSTING TOTAL END PLAY
Reverse Clutch End Play
THRUST WASHERS FOR ADJUSTING REVERSE CLUTCH DRUM END PLAY
Removal and Installtion
Shift Solenoid Valves
Solenoid Valves
A/T Fluid Temperature Sensor
Remarks: Specification data are reference values.
Revolution Sensor (For Speed Sensor)
Dropping Resistor
Power Train Revolution Sensor
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.