Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2002G20 L4-2.0L (SR20DE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSTECHNICAL SERVICE BULLETINSBODY CONTROLS - CONFIGURABLE BCM REPLACEMENT INFORMATION
2002 Infiniti G20 L4-2.0L (SR20DE)
Body Controls - Configurable BCM Replacement Information
2002 Infiniti G20 L4-2.0L (SR20DE)SECTION Body Controls - Configurable BCM Replacement Information
Classification: EC12-016
Reference: ITB12-037
Date: June 26, 2012
WHEN REPLACING CONFIGURABLE BCM
APPLIED VEHICLES: All with configurable BCM
SERVICE INFORMATION:
Before replacing a configurable BCM, always select Save Configuration whether or not it has any manually configurable options.
After replacement "Write Configuration" MUST then be performed and OK selected, even if there are not any options listed. (See Figure 2)
IMPORTANT:
^ Auto settings are not visible in CONSULT III plus and it is not possible to confirm these settings.
^ If original BCM is damaged and "Saving" configuration is not possible:
> Replace BCM, perform the "Write Configuration" and select OK to insure "auto" settings are correct. Even if manual settings are correct or there are no manual settings.
After configuration is completed:
1. Register I-Keys
2. Register Fob (If applicable)
3. Complete TPMS registration
Reference: ITB12-037
Date: June 26, 2012
WHEN REPLACING CONFIGURABLE BCM
APPLIED VEHICLES: All with configurable BCM
SERVICE INFORMATION:
Before replacing a configurable BCM, always select Save Configuration whether or not it has any manually configurable options.
After replacement "Write Configuration" MUST then be performed and OK selected, even if there are not any options listed. (See Figure 2)
IMPORTANT:
^ Auto settings are not visible in CONSULT III plus and it is not possible to confirm these settings.
^ If original BCM is damaged and "Saving" configuration is not possible:
> Replace BCM, perform the "Write Configuration" and select OK to insure "auto" settings are correct. Even if manual settings are correct or there are no manual settings.
After configuration is completed:
1. Register I-Keys
2. Register Fob (If applicable)
3. Complete TPMS registration
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.