Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1995ACCENT L4-1.5L SOHC ALPHA ENGINEREPAIR AND DIAGNOSISCRUISE CONTROLADJUSTMENTS
1995 Hyundai Accent L4-1.5L SOHC Alpha Engine
Cruise Control: Adjustments
1995 Hyundai Accent L4-1.5L SOHC Alpha EngineSECTION Adjustments
1. Remove cover of actuator.
2. Loosen throttle lever and intermediate pulley A, B and C adjusting and locking nuts, so intermediate pulley A, B, C and throttle lever move freely, Fig. 1.
3. Turn ignition switch to ON position, do not start engine.
4. Rotate intermediate pulley C in direction shown, keep pulley in contact with stopper, then tighten adjusting nut C to lessen inner cable play of accelerator cable. Unscrew adjusting nut C no more than 1/2 turn before intermediate pulley C begins to move.
5. Fix accelerator cable with locknut.
6. Tighten adjusting nut B to lessen play of throttle cable. When intermediate pulley B lever touches intermediate pulley C, unscrew adjusting nut B approximately one turn.
7. Fix throttle cable with locknut.
8. Tighten adjusting nut A to lessen inner play of cruise control cable. When intermediate pulley lever A touches intermediate pulley B, unscrew adjusting nut A approximately one turn.
9. Fix cruise cable with locknut.
10. After adjusting, check if end of fixed SAS is touching throttle lever stopper.
Fig. 1 Actuator Cable Adjustments:
2. Loosen throttle lever and intermediate pulley A, B and C adjusting and locking nuts, so intermediate pulley A, B, C and throttle lever move freely, Fig. 1.
3. Turn ignition switch to ON position, do not start engine.
4. Rotate intermediate pulley C in direction shown, keep pulley in contact with stopper, then tighten adjusting nut C to lessen inner cable play of accelerator cable. Unscrew adjusting nut C no more than 1/2 turn before intermediate pulley C begins to move.
5. Fix accelerator cable with locknut.
6. Tighten adjusting nut B to lessen play of throttle cable. When intermediate pulley B lever touches intermediate pulley C, unscrew adjusting nut B approximately one turn.
7. Fix throttle cable with locknut.
8. Tighten adjusting nut A to lessen inner play of cruise control cable. When intermediate pulley lever A touches intermediate pulley B, unscrew adjusting nut A approximately one turn.
9. Fix cruise cable with locknut.
10. After adjusting, check if end of fixed SAS is touching throttle lever stopper.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.