Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2011CR-V EX, 2.4 RE4, BZHAREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 68 (IDLE CONTROL SYSTEM)PCM IDLE LEARN PROCEDURENOTES
2011 Honda CR-V EX, 2.4 RE4, BZHA
PCM Idle Learn Procedure: Notes
2011 Honda CR-V EX, 2.4 RE4, BZHASECTION Notes
WARNING: This page is about a different car, the 2009 Honda CR-V, 2008 Honda CR-V, and 2007 Honda CR-V. However, it is still accessible from the selected car via links, so may be relevant.
The idle learn procedure must be done so the PCM can learn the engine idle characteristics.
Do the idle learn procedure whenever you do any of these actions:
- Replace the PCM.
- Reset the PCM.
- Update the PCM.
- Replace or clean the throttle body.
- Disassemble the engine or the transmission.NOTE: Clearing the DTCs with the HDS does not require you to do the idle learn procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.