Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2011CR-V EX, 2.4 RE4, BZHAREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMFUEL SUPPLY SYSTEMFUEL PRESSURE TEST
2011 Honda CR-V EX, 2.4 RE4, BZHA
Fuel Pressure Test
2011 Honda CR-V EX, 2.4 RE4, BZHASECTION Fuel Pressure Test
Special Tools Required
- Fuel Pressure Gauge 07406-004000B
- Fuel Pressure Gauge Attachment Set 07AAJ-S6MA150
- Relieve the fuel pressure (see FUEL PRESSURE RELIEVING ).
- Attach the fuel pressure gauge set and the fuel pressure gauge.
- Start the engine, and let it idle.
- If the engine starts, go to step 11.
- If the engine does not start, go to step 4.
- Check to see if the fuel pump is running: Listen to the fuel filler port with the fuel fill cap removed. The fuel pump should run for 2 seconds when the ignition switch is first turned to ON (II).
- If the pump runs, go to step 5.
- If the pump does not run, do the fuel pump circuit troubleshooting (see FUEL PUMP CIRCUIT TROUBLESHOOTING ).
- Read the fuel pressure gauge. The pressure should be 324-373 kPa (3.3-3.8 kgf/cm2
, 47-54 psi).
- If the pressure is OK, the test is complete.
- If the pressure is out of specification, replace the fuel pressure regulator (see FUEL PRESSURE REGULATOR REPLACEMENT ) and the fuel filter (see FUEL PRESSURE REGULATOR REPLACEMENT ), then recheck the fuel pressure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.