Torque Specifications - General: Driveline/Axle

2011 Honda CR-V EX, 2.4 RE4, BZHASECTION Driveline/Axle
DRIVELINE/AXLE SPECIFICATIONS CHART

Location Item Remark Torque
Driveline/axle Front spindle nut (26 mm) Use oil on the seating surface Use new nut 328 N.m (33.5 kgf.m, 242 lbf.ft)
Rear spindle nut (24 mm) Use oil on the seating surface Use new nut 245 N.m (25.0 kgf.m, 181 lbf.ft)
Intermediate shaft dowel bolts   39 N.m (4.0 kgf.m, 29 lbf.ft)
Intermediate shaft flange bolt   39 N.m (4.0 kgf.m, 29 lbf.ft)
No. 1 propeller shaft bolts Use new bolts 32 N.m (3.3 kgf.m, 24 lbf.ft)
No. 2 propeller shaft bolts Use new bolts 32 N.m (3.3 kgf.m, 24 lbf.ft)
Center support bearing bolts Use new bolts 39 N.m (4.0 kgf.m, 29 lbf.ft)
No. 1 propeller shaft protector bolts   22 N.m (2.2 kgf.m, 16 lbf.ft)
No. 2 propeller shaft protector bolts   22 N.m (2.2 kgf.m, 16 lbf.ft)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.