Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2011CR-V EX, 2.4 RE4, BZHAREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSPOWER WINDOWSRESETTING THE POWER WINDOW CONTROL UNITWITHOUT THE HDS
2011 Honda CR-V EX, 2.4 RE4, BZHA
Without the HDS
2011 Honda CR-V EX, 2.4 RE4, BZHASECTION Without the HDS
- Turn the ignition switch to ON (II).
- Move the power window all the way down by using the power window DOWN switch.
- Open the driver's or front passenger's door.
- Do the following four times before going to step 5:NOTE: Do each bullet step within 5 seconds of each other.
- Turn the ignition switch to LOCK (0).
- Push and hold the driver's power window DOWN switch.
- Turn the ignition switch to ON (II).
- Release the driver's power window DOWN switch.
- Confirm that AUTO UP no longer works. If AUTO UP still works, repeat step 4, paying close attention to the 5 second time limit.
- Move the power window all the way down using the power window DOWN switch.
- Pull up and hold the power window UP switch until the power window is all the way up, then continue to hold the switch for several seconds.
- Confirm that the power window control unit is reset by using the power window AUTO UP and AUTO DOWN function. If the power window still does not work in AUTO, repeat the procedure several times, paying close attention to the 5 seconds time limit between each bulleted step. If window still does not work, troubleshoot the power window circuit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.