SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2011CR-V EX, 2.4 RE4, BZHAREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSIONTRANSFER ASSEMBLY INSPECTION
2011 Honda CR-V EX, 2.4 RE4, BZHA

Transfer Assembly Inspection

2011 Honda CR-V EX, 2.4 RE4, BZHASECTION Transfer Assembly Inspection
  1. Shift the transmission into N.
  2. Raise the vehicle on a lift, and make sure it is supported securely.
  3. Make a reference mark (A) across the propeller shaft (B) and the transfer companion flange (C).
    Fig 1: Reference Mark Across Propeller Shaft And Transfer Companion Flange With Torque Specification
    G06615706Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Separate the propeller shaft from the transfer companion flange.
  5. Set a dial indicator (A) on the transfer companion flange (B), and measure the transfer gear backlash.

    Standard: 0.06-0.16 mm (0.002-0.006 in) 

    Fig 2: Measuring Transfer Gear Backlash
    G06615707Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. If the backlash is out of the standard, remove the transfer assembly, and adjust the transfer gear backlash (see REASSEMBLY ).
  7. Check for fluid leaks between the mating faces of the transfer assembly and the transmission.
  8. If there is leak, remove the transfer assembly, and replace the O-ring. Also check for fluid leaks between the mating surfaces of the transfer housing and transfer cover. If there is a leak, remove the transfer cover, and replace the O-ring.
  9. Check for leaks between the transfer companion flange and the transfer oil seal.
  10. If there is a leak, remove the transfer assembly from the transmission, and replace the transfer oil seal and the O-ring on the transfer output shaft (hypoid gear). If oil seal and O-ring replacement is required, you will need to check and adjust the transfer gear tooth contact, transfer gear backlash, the tapered roller bearing starting torque, and the total starting torque (see REASSEMBLY ). Do not replace the oil seal with the transfer assembly on the transmission.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.