Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2011CR-V EX, 2.4 RE4, BZHAREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSHEATING/AIR CONDITIONINGMODE CONTROL MOTOR REPLACEMENT
2011 Honda CR-V EX, 2.4 RE4, BZHA
Mode Control Motor Replacement
2011 Honda CR-V EX, 2.4 RE4, BZHASECTION Mode Control Motor Replacement
- Remove the glove box (see GLOVE BOX REMOVAL/INSTALLATION ).
- Remove the wire harness clips (A), the self-tapping screws, and the passenger's heater duct (B).
- Disconnect the 7P connector (A) from the mode control motor (B). Remove the self-tapping screws and the mode control motor from the heater unit.
- Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make sure the motor runs smoothly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.