Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHONDA2011CR-V EX, 2.4 RE4, BZHAREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONRESET PROCEDURESTIRE PRESSURE MONITOR SYSTEMSTORQUE SPECIFICATIONS

2011 Honda CR-V EX, 2.4 RE4, BZHA

Torque Specifications

2011 Honda CR-V EX, 2.4 RE4, BZHASECTION Torque Specifications

TORQUE SPECIFICATIONS

Component

Ft. Lbs. (N.m)

Wheel Nut

80 (108)

INCH Lbs. (N.m)

Tire Pressure Sensor Nut

⁽¹⁾ 35 (4)

⁽¹⁾

Do not reuse any nuts that have been tightened (even one time) to the specified torque, as they are deformed inside. Do not use air or electric impact tools to tighten a valve stem nut. Tightening the nut beyond the specified torque can damage the nut. You may hear a snap or pop as you tighten the nut (this is normal). Make sure that there is no space between the sensor and the wheel.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.