Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHONDA2011CR-V EX, 2.4 RE4, BZHAREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSPOWER LUMBAR SUPPORTSWITCH TEST/REPLACEMENT

2011 Honda CR-V EX, 2.4 RE4, BZHA

Switch Test/Replacement

2011 Honda CR-V EX, 2.4 RE4, BZHASECTION Switch Test/Replacement

Remove the recline cover (see FRONT SEAT RECLINE COVER REMOVAL/INSTALLATION ).
Separate the lumbar support switch cover (A) from the switch (B).

Fig 1: Locating Lumbar Support Switch Cover And Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the 5P connector (C) from the switch.
Check for continuity between the terminals in each switch position according to the table.

Fig 2: Lumbar Support Switch Terminals Continuity Reference Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity is not as specified, replace the switch.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.