Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHONDA2011CR-V EX, 2.4 RE3, MZJAREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSIONSHIFT LEVER INSTALLATION

2011 Honda CR-V EX, 2.4 RE3, MZJA

Shift Lever Installation

2011 Honda CR-V EX, 2.4 RE3, MZJASECTION Shift Lever Installation

Cover the opening of the dashboard with tape to prevent damage to the dashboard.
Install the shift lever assembly (A) in the dashboard.

Fig 1: Shift Lever Assembly In Dashboard With Bolts And Nut With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Connect the shift lock solenoid connector (B) and the D3 switch/park pin switch/A/T gear position indicator panel light connector (C).
Install the shift cable on the shift lever, and adjust the shift cable (see step 7 ).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.