Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P1731: Problem in Shift Control System: General Description
Hydraulic pressure to each clutch is controlled by the shift valve. The shift valve activates according to the ON/OFF status of shift solenoid valves A, B, C, D, and E. Hydraulic pressure supply in D is shown above. The line pressure or the clutch pressure control pressure (CPC A, CPC B, or CPC C) is supplied to each clutch by the shift valve activated. The powertrain control module (PCM) computes the actual ratio of input shaft (mainshaft) and output shaft (countershaft) revolutions. If a difference between the actual ratio and the commanded gear occurs when shifting to each gear position, a malfunction in the A/T clutch pressure control solenoid valve, the shift solenoid valve, or the hydraulic system is detected and a DTC is stored.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.