Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2011CR-V EX, 2.4 RE3, BZJAREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXVTEC/VTC DTCS
2011 Honda CR-V EX, 2.4 RE3, BZJA
VTEC/VTC DTCS
2011 Honda CR-V EX, 2.4 RE3, BZJASECTION VTEC/VTC DTCS
VTEC/VTC (K24Z1) DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC P0010 | VTC Oil Control Solenoid Valve Malfunction |
| DTC P0011 | VTC System Malfunction |
| DTC P0340 | CMP Sensor A No Signal |
| DTC P0341 | CMP Sensor A and CKP Sensor Incorrect Phase Detected |
| DTC P0344 | CMP Sensor A Intermittent Interruption |
| DTC P1009 | VTC Advance Malfunction |
| DTC P2646 | Rocker Arm Oil Pressure Switch Circuit Low Voltage |
| DTC P2647 | Rocker Arm Oil Pressure Switch Circuit High Voltage |
| DTC P2648 | Rocker Arm Oil Control Solenoid Circuit Low Voltage |
| DTC P2649 | Rocker Arm Oil Control Solenoid Circuit High Voltage |
VTEC/VTC (K24Z6) DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC P0010 | VTC Oil Control Solenoid Valve Malfunction |
| DTC P0011 | VTC System Malfunction |
| DTC P0340 | CMP Sensor A No Signal |
| DTC P0341 | CMP Sensor A and CKP Sensor Incorrect Phase Detected |
| DTC P0344 | CMP Sensor A Circuit Intermittent Interruption |
| DTC P1009 | VTC Advance Malfunction |
| DTC P2646 | Rocker Arm Oil Pressure Switch Circuit Low Voltage |
| DTC P2647 | Rocker Arm Oil Pressure Switch Circuit High Voltage |
| DTC P2648 | Rocker Arm Oil Control Solenoid Circuit Low Voltage |
| DTC P2649 | Rocker Arm Oil Control Solenoid Circuit High Voltage |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.