Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2011CR-V EX, 2.4 RE3, BZJAREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMADVANCED DIAGNOSTICSDTC P0706: TRANSMISSION RANGE SWITCH CIRCUIT (OPEN)DRIVING PATTERN
2011 Honda CR-V EX, 2.4 RE3, BZJA
Driving Pattern
2011 Honda CR-V EX, 2.4 RE3, BZJASECTION Driving Pattern
- Start the engine.
- Accelerate the vehicle in D to 30 mph (48 km/h) or more.
- Slow down to 6 mph (10 km/h) for several seconds.
- Stop the vehicle, and turn the ignition switch to LOCK (0).
- Repeat Driving Pattern steps 1 through 3.
- Drive the vehicle in this manner only if the traffic regulations and ambient conditions allow.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.