Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2011CR-V EX, 2.4 RE3, BZJAREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMADVANCED DIAGNOSTICSDTC P0011: VARIABLE VALVE TIMING CONTROL (VTC) SYSTEM MALFUNCTIONENABLE CONDITIONS
2011 Honda CR-V EX, 2.4 RE3, BZJA
Enable Conditions
2011 Honda CR-V EX, 2.4 RE3, BZJASECTION Enable Conditions
ENABLE CONDITIONS
| Condition | Minimum | Maximum | |||||
|---|---|---|---|---|---|---|---|
| Elapsed time after starting the engine | 10 seconds | - | |||||
| Engine coolant temperature | 23 °F (-5 °C)(1) | 158 °F (70 °C) | - | ||||
| -13 °F (-25 °C)(1) | 185 °F (85 °C) | ||||||
| Engine speed | 203 °F (95 °C)(2) | 800 rpm | - | ||||
| 225 °F (107 °C)(2) | 1,600 rpm | ||||||
| Battery voltage | 10.5 V | - | |||||
| Elapsed TDC revolutions | 25 °F (-4 °C)(1) | Per 0 revolutions | - | ||||
| -13 °F (-25 °C)(1) | Per 23,500 revolutions | ||||||
| No active DTCs set (prevents monitor from running) | P0010, P0107, P0108, P0112, P0113, P0117, P0118, P0122, P0123, P0222, P0223, P0335, P0339, P0340, P0341, P0344, P060A, P1009, P1109, P1128, P1129, P1659, P2101, P2118, P2122, P2123, P2127, P2128, P2135, P2138, P2176, P2227, P2228, P2229, P2646, P2647, P2648, P2649 | ||||||
|
|||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.