SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2011CR-V EX, 2.4 RE3, BZJAREPAIR AND DIAGNOSISENGINE MECHANICALMECHANICALENGINE ASSEMBLYENGINE INSTALLATION
2011 Honda CR-V EX, 2.4 RE3, BZJA

Engine Installation

2011 Honda CR-V EX, 2.4 RE3, BZJASECTION Engine Installation

Special Tools Required 

  • Universal Lifting Eyelet 07AAK-SNAA120
  • Engine Hanger Adapter VSB02C000015*
  • Subframe Adapter VSB02C000016*
  • CR-V Engine Hanger Adapter VSB02C000032*
  • Engine Support Hanger, A and Reds AAR-T1256*

*Available through the Honda Tool and Equipment Program, 888-424-6857.

  1. Install the accessory brackets, and tighten their bolts to the specified torque.
    Fig 1: Accessory Brackets And Bolts With Torque Specifications
    G06609005Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Raise the vehicle on the lift, and position the engine/transmission assembly under the vehicle. Lower the vehicle and attach the universal lifting eyelet (A) and transmission hook (B) to the chain hoist, then lift the engine into position.
    NOTE: Reinstall the mounting bolts and support nuts in the sequence given in the following steps. Failure to follow this sequence may cause excessive noise and vibration, and reduce engine mount life.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.