Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2006PILOT LX, 3.5 YF1, J35A9REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMIDLE CONTROL SYSTEMPCM IDLE LEARN PROCEDUREPROCEDURE
2006 Honda Pilot LX, 3.5 YF1, J35A9
PCM Idle Learn Procedure: Procedure
2006 Honda Pilot LX, 3.5 YF1, J35A9SECTION Procedure
- Make sure all electrical items (A/C, audio, lights, etc.) are off.
- Reset the PCM with the HDS.
- Turn the ignition switch ON (II), and wait 2 seconds.
- Start the engine. Hold the engine speed at 3,000 RPM without load (in Park or neutral) until the radiator fan comes on, or until the engine coolant temperature reaches 194°F (90°C).
- Let the engine idle for about 5 minutes with the throttle fully closed.NOTE: If the radiator fan comes on, do not include its running time in the 5 minutes.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.