SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2006PILOT LX, 3.5 YF1, J35A9REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSKEYLESS/POWER DOOR LOCKS/SECURITY SYSTEMTRANSMITTER PROGRAMMING
2006 Honda Pilot LX, 3.5 YF1, J35A9

Transmitter Programming

2006 Honda Pilot LX, 3.5 YF1, J35A9SECTION Transmitter Programming

Storing transmitter codes:

The codes of up to three transmitters can be read into the keyless receiver unit memory. (If a fourth code is stored, the code which was input first will be erased.)

NOTE: It is important to maintain the time limits between the steps. Make sure the doors, hood and tailgate are closed.
  1. Turn the ignition switch ON (II).
  2. Within 1 to 4 sec, press the transmitter lock or unlock button.
  3. Within 1 to 4 sec, turn the ignition switch OFF.
  4. Within 1 to 4 sec, turn the ignition switch ON (II).
  5. Within 1 to 4 sec, press the transmitter lock or unlock button.
  6. Within 1 to 4 sec, turn the ignition switch OFF.
  7. Within 4 sec, turn the ignition switch ON (II).
  8. Within 1 to 4 sec, press the transmitter lock or unlock button.
  9. Within 1 to 4 sec, turn the ignition switch OFF.
  10. Within 4 sec, turn the ignition switch ON (II).
  11. Within 1 to 4 sec., press the transmitter lock or unlock button.
  12. The door lock acuators will activate to confirm that the system has entered the tranmitter programming mode. Within 1 to 4 seconds, push the transmitter lock or unlock button again to program that transmitter. The door lock actuator will activate to confirm that the transmitter code is stored.
  13. Within 10 seconds, press the transmitter lock or unlock buttons on the two additional transmittes. The door lock acuators will activate each time after you press the lock actuators will activate each time after you press the lock or unlock button to confirm that the transmitter code is stored.
  14. Turn the ignition switch OFF, and pull out the key.
  15. Confirm proper operation with the new code(s).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.