Shift Lever Installation

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) in the SRS before doing repairs or service.

1. Install the shift lever assembly (A) on the steering column, and install the harness clamp (B).
   Fig 1: Shift Lever Assembly And Harness Clamp With Torque Specifications

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Connect the shift lock solenoid connector (C) and park pin switch connector (D).
3. Push the shift cable (A) until it stops, then release it. Pull the shift cable back two steps so that the shift position is in N. Do not hold the shift cable guide (B) and damper (C) to adjust the shift position.
   Fig 2: Push And Pull Shift Cable So Shift Position Is In Neutral

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Turn the ignition switch ON (II), and check that the N position indicator comes on.
   Fig 3: Identifying Neutral (N) Position Indicator In Gauge Module

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Turn the ignition switch OFF.
6. Place the shift lever in the N position, then insert a 6.0 mm (0.24 in.) pin (A) through the positioning hole (B) on the detent plate, and into the positioning hole (C) on the control bracket. The shift lever is secured in the N position.
   Fig 4: Placing Shift Lever In N Position, Insert A 6.0 Mm (0.24 In.) Pin Into Positioning Hole

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
7. Align the socket holder (A) on the shift cable (B) with the slot in the socket holder bracket (C), then slide the holder into the bracket. Install the shift cable end (D) over the mounting stud (E) by aligning its square hole (F) with the square fitting (G) at the bottom of the stud. Rotate the holder a quarter turn to secure the shift cable. Do not install the shift cable by holding the shift cable guide (H) and damper (I).
   Fig 5: Installing Shift Cable (Shift Lever Side)

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
8. Check that the shift cable end (A) is properly installed on the mounting stud (B).
   Fig 6: Checking Shift Cable End (A) Is Properly Installed

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
9. If improperly installed, remove the shift cable from the socket holder bracket, and reinstall the shift cable. Do not install the shift cable end on the mounting stud while the shift cable is on the socket holder bracket.
10. Install and tighten the nut.
    Fig 7: Shift Cable End (Shifter Lever Side) With Torque Specifications

    Courtesy of AMERICAN HONDA MOTOR CO., INC.
11. Remove the 6.0 mm (0.24 in.) pin that was installed to hold the shift lever.
12. Turn the ignition switch ON (II). Move the shift lever to each position, and check that the A/T gear position indicator follows the transmission range switch.
13. Install the instrument panel (see INSTRUMENT PANEL REMOVAL/INSTALLATION ).
14. Install the steering column covers (see INSTALLATION ).