Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHONDA2006PILOT EX, 3.5 YF2, J35Z1REPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONRESET PROCEDURESTIRE PRESSURE MONITOR SYSTEMSTORQUE SPECIFICATIONS

2006 Honda Pilot EX, 3.5 YF2, J35Z1

Torque Specifications

2006 Honda Pilot EX, 3.5 YF2, J35Z1SECTION Torque Specifications

TORQUE SPECIFICATIONS

Component

Ft. Lbs. (N.m)

Wheel Nut

2005-08 Pilot

80 (108)

All Other Models

94 (127)

INCH Lbs. (N.m)

Tire Pressure Sensor Nut

⁽¹⁾ 35 (4)

⁽¹⁾

Do not reuse any nuts that have been tightened (even one time) to the specified torque, as they are deformed inside. Do not use air or electric impact tools to tighten a valve stem nut. Tightening the nut beyond the specified torque can damage the nut. You may hear a snap or pop as you tighten the nut (this is normal). Make sure that there is no space between the sensor and the wheel.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.