Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P0116: ECT Sensor 1 Circuit Range/Performance Problem
- Turn the ignition switch ON (II).
- Check ECT SENSOR 1 in the DATA LIST with the HDS.
Is about 176°F (80°C) or more, or 0.78 V or less indicated?
YES -Go to step 6.
NO -Go to step 3.
- Note the value of ECT SENSOR 1 in the DATA LIST with the HDS.
- Start the engine. Hold the engine speed at 3,000 RPM without load (in Park or neutral) until the radiator fan comes on, then let it idle.
- Check ECT SENSOR 1 in the DATA LIST with the HDS.
Does ECT SENSOR 1 change 18°F (10°C) or more?
YES -Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at ECT sensor 1 and the PCM.
NO -Go to step 11.
- Note the value of ECT SENSOR 1 in the DATA LIST with the HDS.
- Turn the ignition switch OFF.
- Open the hood, and let the engine cool for 3 hours.
- Turn the ignition switch ON (II).
- Check ECT SENSOR 1 in the DATA LIST with the HDS.
Does ECT SENSOR 1 change 18°F (10°C) or more?
YES -Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at ECT sensor 1 and the PCM.
NO -Go to step 11.
- Turn the ignition switch OFF.
- Replace ECT sensor 1 (see ECT SENSOR 1 REPLACEMENT ).
- Turn the ignition switch ON (II).
- Reset the PCM with the HDS.
- Do the PCM idle learn procedure (see PCM IDLE LEARN PROCEDURE ).
- Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0116 indicated?
YES -Check for poor connections or loose terminals at ECT sensor 1 and the PCM, then go to step 1.
NO -Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.