Long Block: Remove & Replace

2006 Honda Pilot EX, 3.5 YF2, J35Z1SECTION Remove & Replace
WARNING: This page is about the Pilot EX, 3.5 YF1, J35A9, which is a different variant/trim than selected.
Consists of a Cylinder Block fitted with Pistons, Rings, Connecting Rods, Crankshaft and all Bearings, Cylinder Head(s), Camshaft(s), Timing Chain or Belt and Sprockets or Gears. Includes (where applicable): Clean and transfer Fuel and Electrical Assemblies, Engine Mounts, Manifolds, Valve Cover(s), Oil Pan, Oil Pump, Timing Cover(s), Water Pump, Clutch and Flywheel. Adjust Valves.

Applies ToNoteStandard HoursWarranty HoursSkill Level
4WD19.7A
Additional Procedure: LONG BLOCK: Remove & Replace:
Where Cruise Cont interferes add0.3A
Where Pwr Strg interferes add0.3A
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.