Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2006PILOT EX, 3.5 YF2, J35A9REPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSIONATF TEMPERATURE SENSOR REPLACEMENT
2006 Honda Pilot EX, 3.5 YF2, J35A9
ATF Temperature Sensor Replacement
2006 Honda Pilot EX, 3.5 YF2, J35A9SECTION ATF Temperature Sensor Replacement
- Remove the splash shield.
- Drain the automatic transmission fluid (ATF) (see step 3 ).
- Disconnect the ATF temperature sensor connector (A), then remove the connector from the connector bracket (B).
- Remove the harness clamp (C) from its bracket (D).
- Remove the ATF temperature sensor (E).
- Install a new O-ring (F) on the new ATF temperature sensor, and install the ATF temperature sensor.
- Check the connector for rust, dirt, or oil. Connect the connector securely, and install it on its bracket.
- Install the harness clamp on its bracket.
- Refill the transmission with the ATF (see step 5 ).
- Install the splash shield.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.