Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2006PILOT EX, 3.5 YF2, J35A9REPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCOMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORCIRCUIT PROTECTION DEVICES
2006 Honda Pilot EX, 3.5 YF2, J35A9
Circuit Protection Devices
2006 Honda Pilot EX, 3.5 YF2, J35A9SECTION Circuit Protection Devices
CIRCUIT PROTECTION DEVICES LOCATION
| Component | Location |
|---|---|
| A/C Diode Assembly | Behind right kick panel. See Figure . |
| Auxiliary Fuse Box | Left side of engine compartment. See Figure . |
| Auxiliary Under-Hood Relay Box | Right front of engine compartment. See Figure . |
| Back-Up Sensor In-Line Fuse | Right rear of cargo area. See Figure . |
| Driver's Under-Dash Fuse/Relay Box | Below left end of dash. See Figure . |
| In-Line Diode No. 1 | In driver's underdash fuse/relay box. See Figure . |
| In-Line Diode No. 2 | In driver's underdash fuse/relay box. See Figure . |
| In-Line Diode No. 3 | In passenger's underdash fuse/relay box. See Figure . |
| In-Line Diode No. 4 | In passenger's underdash fuse/relay box. See Figure . |
| In-Line Fuse 1 | Behind right kick panel. See Figure . |
| Passenger's Under-Dash Fuse/Relay Box | Behind right kick panel. See Figure . |
| Shift Lock Diode (A & B) | Under left side of dash. See Figure . |
| Underhood Fuse/Relay Box | Right side of engine compartment. See Figure . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.