Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2006PILOT EX, 3.5 YF2, J35A9REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTNAVIGATION SYSTEMSYSTEM DIAGNOSTIC MODEERROR MESSAGE TABLE
2006 Honda Pilot EX, 3.5 YF2, J35A9
Error Message Table
2006 Honda Pilot EX, 3.5 YF2, J35A9SECTION Error Message Table
ERROR MESSAGE
| Screen Error Message | Solution |
|---|---|
| Navigation system is unable to acquire a proper GPS signal. | Make sure there is nothing on the dashboard blocking the GPS antenna. If not, move the vehicle to an open space away from tall buildings, trees, etc. After market devices can affect the GPS reception. |
| Navigation unit door is open or No DVD disc installed. Please check system. | Make sure the correct white-labeled navigation DVD is installed with the label side up, and the navigation unit door is snapped fully closed (see FORCED STARTING OF DISPLAY ). |
| No DVD disc, please check system. | Check that the navigation DVD is installed with the label side up check the DVD color. |
| Display temp is too high. System will shut down until display cools down. | This message will appear briefly when the display temperature is too high, and the display will turn off until the temperature cools down. The system will turn back on when the display cools down. |
| Outside temperature is low, system will take a while to start up. | The temperature is below -30°C, and the navigation ECU has difficulties reading the DVD. The system will start up when the temperature warms up. |
| DVD disc reading error (unformatted), please consult your dealer. | Check the DVD source for deep scratches or other damage. Make sure you are using an official Honda navigation DVD (white in color). The system cannot read other mapping databases or video DVDs. If the problem persists, see your dealer check the DVD color. |
| Route has not been completed. Please try again from a different location. | Routing to or from a place (new area) that is not in the database. Try planning a different route to or from a different location. |
| No alternate route found. Original route will be guided. | No alternate route method was found. The original route will be used. |
| This destination cannot be found in database. | The destination was not found in the database. Try another destination nearby, or select the destination with the joystick. |
| Please operate climate control after starting engine. | The engine needs to be running to operate the climate control system. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.