Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
A/C Signal Circuit Troubleshooting
- Start the engine.
- Turn the blower switch on.
- Turn the A/C switch on.
- Check the A/C CLUTCH in the DATA LIST with the HDS.
Does it indicate ON?
YES - Go to step 5.
NO - Do the A/C Pressure Switch Circuit Troubleshooting (see A/C PRESSURE SWITCH CIRCUIT TROUBLESHOOTING ).
- Check the A/C system.
Does the A/C system operate?
YES - The air conditioning system circuit is OK.
NO - Go to step 6.
- Turn the ignition switch OFF.
- Turn the ignition switch ON (II).
- Activate the A/C CLUTCH in the INSPECTION MENU with the HDS.
Is there a clicking noise from the A/C compressor clutch?
YES - Do the A/C System Test (see A/C SYSTEM TEST ).
NO - Go to step 9.
- Turn the ignition switch OFF.
- Jump the SCS line with the HDS.
- Disconnect PCM connector A (44P).
- Turn the ignition switch ON (II).
- Momentarily connect PCM connector terminal A14 to body ground with a jumper wire several times.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there a clicking noise from the A/C compressor clutch?
YES - Update the PCM if it does not have the latest software (see PCM UPDATING AND SUBSTITUTION FOR TESTING ), or substitute a known-good PCM (see HOW TO SUBSTITUTE THE PCM ), then recheck. If the symptom/indication goes away with a known-good PCM, replace the original PCM (see PCM REPLACEMENT ).
NO - Check for poor connections or loose terminals at the A/C clutch relay and the PCM. If the connections are OK, check the A/C clutch relay (see POWER RELAY TEST ), repair open in the wire between the PCM (A14) and the A/C clutch relay and the other A/C systems.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.