Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Piston, Pin, and Connecting Rod Replacement: Reassembly
2002 Honda Civic SiSECTION Reassembly
WARNING: This page is about a different variant/trim than selected.
- Assemble the piston and connecting rod with the connecting rod oil hole (A) facing the "IN" mark (B).
- Insert the pilot collar (A) into the piston and connecting rod.
- With the embossed mark facing up, place the piston assembly (B) on the special tool (C). Be sure you position the recessed flat on the piston against the lugs on the base attachment.
- Press the pin (D) in with the pin driver (E) and a hydraulic press.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.