SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2002CIVIC SIREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 8 (OVERHAUL - 1.7L ENGINE)CKP SENSOR REPLACEMENT
2002 Honda Civic Si

CKP Sensor Replacement

2002 Honda Civic SiSECTION CKP Sensor Replacement
WARNING: This page is about a different variant/trim than selected.
  1. Remove the grommet (A) from the upper cover, and disconnect the camshaft position (CMP) (top dead center (TDC)) sensor connector (B).
    Fig 1: Removing Grommet From Upper Cover With Torque Specifications
    G01401651Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Remove the upper cover (C) and lower cover (D).
  3. Disconnect the crankshaft position (CKP) sensor connector, then remove the CKP sensor from the oil pump.
    Fig 2: Disconnecting CKP Sensor Connector With Torque Specifications
    G01401652Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the CKP sensor in reverse order of removal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.