Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2002CIVIC SIREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 93 (SEATS)FRONT SEAT COVER REPLACEMENTNOTES
2002 Honda Civic Si
Front Seat Cover Replacement: Notes
2002 Honda Civic SiSECTION Notes
WARNING: This page is about a different car, the 2006 Acura MDX, 2005 Acura MDX, 2004 Acura MDX, and 2003 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
SRS components are located in this area. Review the SRS component locations for the appropriate model:
- '03 model (see 2003 MODEL )
- '04-06 models (see 2004-2006 MODELS )
Also review the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before performing repairs or service.
- The operation of the driver's seat position sensor must be checked (see OPERATION CHECK OF THE DRIVER'S SEAT POSITION SENSOR (SPS)
) after any of these procedures:
- - Driver's seat position sensor replacement
- - Cover plate (front side of driver's seat slide rail) replacement
- The seat weight sensor (SWS) unit must be calibrated (see CALIBRATING THE FRONT PASSENGER'S WEIGHT SENSOR UNIT
) after any of these procedures:
- - Front passenger's seat replacement (including any seat components)
- - Replacement of the seat weight sensors
- - Replacement of the seat weight sensor unit
NOTE:
- Seats with airbags are marked "SIDE AIRBAG" on the seat-back. Because the component parts (seat-back cover, cushion, etc.) of seats with and without airbags are different, make sure you install only the correct replacement parts.
- Do not repair torn or frayed seat-back covers. If necessary, replace the seat-back cover.
- Take care not to tear the seams or damage the seat covers.
- Do not touch the OPDS sensor in the seat-back pad, and keep it away from oils. Oils can corrode the sensor causing it to fail.
- Put on gloves to protect your hands.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.