Mirror Holder Replacement

2002 Honda Civic SiSECTION Mirror Holder Replacement
WARNING: This page is about a different car, the 2006 Acura MDX, 2005 Acura MDX, 2004 Acura MDX, and 2003 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Push in the bottom of the mirror holder (A).
    Fig 1: Pushing Bottom Of Mirror Holder
    G03641533Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Insert a flat-tip screwdriver wrapped with a shop towel at the bottom gap between the mirror holder and mirror (B). Push the mirror holder upward to release the hooks (C, D) from the actuator adapter plate (E) while holding the mirror holder.
  3. Disconnect the mirror defogger terminals (A).
    Fig 2: Disconnecting Mirror Defogger Terminals
    G03641534Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the mirror holder in the reverse order of removal, and note these items:
    • Make sure the terminals are plugged in properly.
    • Push the mirror holder downward to lock in the hooks.
    • Push in the bottom of the mirror fully before you push on the mirror holder.
    • Check the operation of the actuator.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.