Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2002CIVIC SIREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 81 (POWER STEERING SYSTEM)PUMP OVERHAULEXPLODED VIEWDISASSEMBLY
2002 Honda Civic Si
Exploded View: Disassembly
2002 Honda Civic SiSECTION Disassembly
WARNING: This page is about a different car, the 2006 Acura MDX, 2005 Acura MDX, 2004 Acura MDX, and 2003 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Refer to the Exploded View as needed during the following procedure.
- Drain the fluid from the pump by turning the pulley.
- Remove the power steering pump (see PUMP REPLACEMENT ).
- Hold the power steering pump (A) in a vise with soft jaws (B), hold the pulley (C) with the special tool, and remove the pulley nut (D) and pulley. Be careful not to damage the pump housing with the jaws of the vise.
- Remove the inlet joint and O-ring.
- Loosen the flow control valve cap with a hex wrench, and remove it, the O-ring, the flow control valve, and spring.
- Remove the pump cover and pump cover seal.
- Remove the outer side plate, pump cam ring, pump rotor, pump vanes, side plate, and O-rings.
- Remove the internal snap ring, then remove the pump driveshaft by tapping on the shaft end with the plastic hammer. Remove the pump seal.
- Remove the snap ring and subvalve.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.