SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2002CIVIC SIREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 60 (CRUISE CONTROL)CRUISE CONTROL MAIN SWITCH TEST/ REPLACEMENT
2002 Honda Civic Si

Cruise Control Main Switch Test/ Replacement

2002 Honda Civic SiSECTION Cruise Control Main Switch Test/ Replacement
WARNING: This page is about a different car, the 2006 Acura MDX, 2005 Acura MDX, 2004 Acura MDX, and 2003 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driver's dashboard lower cover (see DASHBOARD LOWER COVER REMOVAL/INSTALLATION ).
  2. Release the clips of the main switch, and push the main switch (A) out of the panel, then disconnect the 8P connector (B) from the main switch.
    Fig 1: Pushing Main Switch Out Of Panel
    G03639206Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between the terminals in each switch position according to Fig 2 . If there is no continuity, replace illumination bulbs (A) or the switch.
    Fig 2: Checking For Continuity Between Terminals In Each Switch Position
    G03639207Courtesy of AMERICAN HONDA MOTOR CO., INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.