SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2002CIVIC SIREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 191 (REAR ENTERTAINMENT SYSTEM)DVD PLAYER UNIT REMOVAL/INSTALLATION
2002 Honda Civic Si

DVD Player Unit Removal/Installation

2002 Honda Civic SiSECTION DVD Player Unit Removal/Installation
WARNING: This page is about a different car, the 2006 Honda Odyssey and 2005 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before performing repairs or service.

NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the dashboard and related parts.
  • If a disc is loaded remove it before continuing.
  1. Remove the center lower cover (see DASHBOARD CENTER LOWER COVER REMOVAL/INSTALLATION ).
  2. Remove the screws and pull out the DVD player unit (A).
    Fig 1: Pulling Out DVD Player Unit
    G03707353Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the wire harness clip (B), then disconnect the 22P connector and digital audio 2P connector (C) from the DVD player unit.
  4. Remove the four mounting screws, then remove the bracket.
    Fig 2: Removing Bracket
    G03707354Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install in the reverse order of removal, and make sure the DVD player unit connectors are plugged in properly. Then test the DVD player unit operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.